Getting to Know Your Envoy XUV
14
Air Inflator System (if equipped)
Locate the air
inflator unit
• The inflator unit
and an on/off
switch are locat-
ed behind an
access cover in
the rear compart-
ment on the driv-
er side of the
vehicle near the
tailgate.
•A22-foot hose and three nozzle
adapters are located in the glove box.
Use the air inflator
• Open the access cover.
• Attach the appropriate nozzle adapter
to the end of the hose (if required).
• Attach that end of the hose to the
object you are inflating. Attach the
other end of the hose to the inflator
outlet.
• Press and release the on/off switch to
turn the air inflator on.
• An indicator light verifies that the
inflator is running.
•When inflation is complete, press and
release the on/off switch again.
• Remove the hose from the outlet
(load leveling will not operate when
the hose is attached to the outlet).
See Section 5 of your Owner Manual.
Four-Wheel Drive (if equipped)
Envoy XUV’s four-wheel drive system
rotary controls are located on the instru-
ment panel.
Shift into 4HI or A4WD
•Turn the knob to 4HI or A4WD. This
can be done at any speed except
when shifting from 4LO.
Shift into 2HI
•Turn the knob to 2HI. This can be
done at any speed except when shift-
ing from 4LO.
Shift into or out of 4LO
• With the ignition in RUN and the vehi-
cle stopped or moving less than 3
mph (4.8 km/h), shift the transmission
into neutral.
•Turn the knob to the 4LO or the 2HI,
4HI or A4WD, preferably with the
vehicle moving 1 to 2 mph (1.6 to 3.2
km/h).
•Wait for the indicator lamp to stop
flashing and remain illuminated; then
shift your transmission into gear.
EnvoyXUV2004_final.qxd 9/5/03 10:51 AM Page 14
To Next Page
Loading...
