Removing the Spare Tire and Tools
The jacking equipment you’ll need is stored along the
driver’s side inner rear quarter panel. In some cases,
you may have to remove the spare tire in order to
reach the jack. Your vehicle is also equipped with
work gloves and a plastic ground mat to assist in the
changing of a flat tire.
The following instructions explain how to remove the
spare tire, depending on where it is mounted on
your vehicle. See Compact Spare Tire on page 5-89 or
Spare Tire on page 5-90 for more information about
the spare.
A. Retainer
B. Rubber Band
(Some Models)
C. Jack Storage Cover
D. Wheel Blocks
E. Hub Cap Removal
Tool (Some Models)
F. Wheel Wrench
G. Jack
H. Jacking Instructions
(Roll and place
instructions above
the jack after it is
installed)
1. To remove your jack cover, pull up on the latch(es)
on the cover (C). Remove the wheel blocks (D),
jack (G) and wheel wrench (F).
5-78
To Next Page
Loading...
