Vehicle Care 10-39
2. Press down on the blade
assembly pivot locking tab. Pull
down on the blade assembly
to release it from the wiper
arm hook.
3. The insert has two notches at
one end that are locked by
bottom claws of the blade
assembly. At the notched end,
pull the insert from the blade
assembly.
4. To install the new wiper insert,
slide the notched end last, into
the end with two blade claws.
Then slide the insert all the way
through the blade claws at the
opposite end.
5. Make sure that the notches
are locked by the bottom claws.
Make sure that all other claws
are properly locked on both
sides of the insert slot.
6. Put the blade assembly pivot in
the wiper arm hook. Pull it up
until the pivot locking tab locks
in the hook slot.
7. Carefully lower the wiper arm
and blade assembly into the
windshield.
Bulb Replacement
For the proper type of replacement
bulbs, see Replacement Bulbs on
page 10‑44.
For any bulb‐changing procedure
not listed in this section, contact
your dealer.
Halogen Bulbs
{
WARNING
Halogen bulbs have pressurized
gas inside and can burst if you
drop or scratch the bulb. You or
others could be injured. Be sure
to read and follow the instructions
on the bulb package.
To Next Page
Loading...
