AM-FM Radio
Playing the Radio
ON (Power): Press this knob to turn the system
on and off.
VOL (Volume): Turn this knob clockwise or
counterclockwise to increase or to decrease the
volume.
DISP (Display): Press this knob to switch the
display between the radio station frequency,
the time, and the alarm status.
Finding a Station
BND (Band): Press this button to switch between
FM or AM. The display shows the selection.
zy (Tune): Press the down z arrow to go
to the previous radio frequency. Press the
up
y arrow to go to the next radio frequency.
To seek stations, press and hold either the
down
z or up y arrow for a second or longer.
The radio seeks to the next or previous station.
The radio only seeks stations with a strong signal
that are in the selected band.
t (Scan): Press the t button to scan radio
stations. The radio goes to a station, plays for a
few seconds, then goes to the next station.
Press the
t button again to stop scanning.
The radio only scans stations with a strong signal
that are in the selected band.
139
To Next Page
Loading...
