Setting Preset Stations
Up to 10 stations (five FM and five AM) can be
programmed on the five numbered pushbuttons,
by performing the following steps:
1. Turn the radio on.
2. Press AM FM to select AM or FM.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons for two seconds or longer.
When that numbered pushbutton is pressed,
the station that was set returns.
5. Repeat the steps for each pushbutton.
Setting the Tone (Bass/Treble)
TONE: To adjust the bass, turn the control ring
behind the power/volume knob counterclockwise.
To adjust the treble, turn the control ring behind
the power/volume knob clockwise. If a station
is weak or has static, decrease the treble.
Adjusting the Speakers (Balance/Fade)
PULL BAL (Balance): To adjust the balance
between the right and the left speakers, pull the
power/volume knob out. Turn the knob to move
the sound to the right or the left speakers. The
middle position balances the sound between the
speakers. Push the knob back in when not in use.
143
To Next Page
Loading...
