GMC Terrain 2017 - Vehicle Messages

GMC Terrain/Terrain Denali Owner Manual (GMNA-Localizing-MidEast-
10292861) - 2017 - crc - 5/9/16
Instruments and Controls 111
and 59 seconds (99:59:59) after
which the display will return to zero.
To stop the timer, press SET/CLR
briefly while Timer is displayed. To
reset the timer to zero, press and
hold SET/CLR.
Navigation
This display is used for the
Navigation System Turn-by-Turn
guidance. See the Navigation
manual if the vehicle has navigation.
Blank Display
This display shows no information.
Vehicle Information Menu
Items
Press the MENU button until Vehicle
Information Menu is displayed. Then
press
R to scroll through the
following menu items:
.
Unit
.
Tire Pressure
.
Remaining Oil Life
.
Blank Display
Unit
Press SET/CLR to enter the unit
menu. Then press
Q or R to switch
between METRIC or US when the
Unit display is active. Press SET/
CLR to confirm the setting. This will
change the displays on the cluster
and DIC to either metric or English
(US) measurements.
Tire Pressure
The display will show a vehicle with
the approximate pressures of all
four tires. Tire pressure is displayed
in either kilopascal (kPa) or in
pounds per square inch (psi).
See Tire Pressure Monitor System
0 223 and Tire Pressure Monitor
Operation 0 224 for more
information.
Remaining Oil Life
This display shows an estimate of
the oil's remaining useful life.
If REMAINING OIL LIFE 99% is
displayed, that means 99% of the
current oil life remains.
When the remaining oil life is low,
the CHANGE ENGINE OIL SOON
message will appear on the display.
See Engine Oil Messages 0 114.
The oil should be changed as soon
as possible. See Engine Oil 0 193.
In addition to the engine oil life
system monitoring the oil life,
additional maintenance is
recommended in the Maintenance
Schedule. See Maintenance
Schedule 0 256.
Remember, the Oil Life display must
be reset after each oil change. It will
not reset itself. Also, be careful not
to reset the Oil Life display
accidentally at any time other than
when the oil has just been changed.
It cannot be reset accurately until
the next oil change. To reset the
engine oil life system, press SET/
CLR while the Oil Life display is
active. The display will ask for
confirmation of a reset. Press
Q or
R to select Yes or No. Then press
SET/CLR to confirm the selection.
See Engine Oil Life System 0 196.
Blank Display
This display shows no information.