GMC Terrain 2025 - Universal Remote System Operation

GMC Terrain/Terrain Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-18552429) - 2025
108 Instruments and Controls
the a
ntenna wire. If you have any difficulty
f
inding the button, refer to the garage door
opener manufacturer’s instructions.
7. Press and release the Learn or Smart button
on the garage door opener receiver. Step
8must be completed within 30 seconds
of pressing this button. If it takes longer
than 30 seconds, you will need to press this
button again.
8. Return to the vehicle and press the Test
button on the infotainment screen. You
may need to press the Test button several
times. If your garage door moves, then
programming was successful. Press the It
Worked button to validate programming
was successful and end the process.
9. If programming is not successful, press It
Didn’t Work button and repeat Steps 6–8.
After your Universal Remote has been
successfully programmed, you can change the
name of the remote on the screen as desired
by pressing y.
For questions or programming help, visit
www.homelink.com/gm for self-help videos
or call 1–800–355–3515. For calls placed outside
the U.S., Canada, or Puerto Rico, international
ra
tes will apply and may differ based on
landline or mobile phone.
Erasing Universal Remotes
To erase aprogrammed Universal Remote,
press y next to the remote from the list on
the infotainment screen, and then select
“Delete.”
To erase ALL programmed Universal Remotes,
press y next to any remote from the list on
the infotainment screen, and then select
“Delete All.”
Radio Signals for Some Gate Operators
Some gate operators and radio-frequency laws
require transmitter signals to time out or
quit after several seconds of transmission.
This may not be long enough for the
Universal Remote system to pick up the signal
during programming.
If programming did not work, replace Step
3under “Programming the Universal Remote
System,” with the following:
Press and release the hand-held transmitter
button every two seconds until the
signal has been found by the Universal
Remote System. Proceed to Step 4under
“P
rogramming the Universal Remote System”
to complete programming.
Using Universal Remotes
Each successfully programmed remote will
create ashortcut icon on the infotainment
Controls screen. Tapping these shortcut icons
will operate the garage door opener. Pressing
and dragging an icon allows it to be
repositioned on the screen as desired.
These shortcut icons may appear in the smart
controls area of the infotainment screen when
your vehicle is in close proximity to the area
in which the Universal Remote System was
programmed, e.g., your home.
Universal Remote System
Operation
Using the Universal Remote System
Press the desired Universal Remote button on
the infotainment screen or the front center
console, depending on the vehicle.