GMC Terrain 2025 - Page 36

GMC Terrain/Terrain Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-18552429) - 2025
Seats and Restraints 35
later in this section. The memory recalls may
b
e
cancelled at any time during the recall.
See “Cancel Memory Seating Recalls” later in
this section.
Identifying Driver Number
The vehicle identifies the current driver by
their remote key number 1–8. The current
remote key number may be identified by Driver
Information Center (DIC) message. For Seat
Entry Memory to work properly, save positions
to the 1 or 2 memory button matching the driver
number of this message. To aid in identifying
remote key IDs, it is recommended to only carry
one remote key when entering the vehicle.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to 1and 2:
1. Turn the vehicle on or to accessory mode.
2. Adjust all available memory features to the
desired driving position.
3. Press and release SET; achime will
sound. ADIC message may indicate to
press memory button 1or 2to save
seating position.
4. Immediately upon releasing SET, press and
ho
ld memory button 1or 2matching the
current Driver’s remote key number until
two chimes sound. If too much time passes
between releasing SET and pressing 1or
2, the two beeps will not sound indicating
memory position were not saved. Repeat
Steps 3and 4to try again.
5. Repeat Steps 1–4 for the other remote key
1 or 2 using the other 1 or 2 memory button.
It is recommended to save the preferred driving
positions to both 1and 2if you are the
only driver.
To save the common exit seating position to
B that is used by all drivers for Manually
Recalling Seating Positions and Auto Seat Exit
Memory Recall features, repeat Steps 1–4 using
B, the exit button.
Manually Recalling Seating Positions
Press and hold 1, 2, or B button until the
recall is complete, to recall the positions
previously saved to that button.
Manual Memory recall movement for 1, 2 or B
buttons may be initiated and will complete to
the saved memory position if the vehicle is in
or out of P (Park).
Enabling Automatic Recalls
•
Se
at Entry Memory moves the driver seat
to the selected 1or 2position when the
vehicle is started. Select Settings >Vehicle
>Seating Position >Seat Entry Memory
>On or Off. See “Auto Seat Entry Memory
Recall” later in this section.
•
Seat Exit Memory moves the driver seat to
the preferred exit position of the B
button when the vehicle is turned off and
the door is opened. Select Settings > Vehicle
> Seating Position > Seat Exit Memory > On
or Off. See “Auto Seat Exit Memory Recall”
later in this section.
Auto Seat Entry Memory Recall
Seat Entry Memory will automatically begin
movement to the seating positions of the 1or
2button corresponding to the driver’s remote
key number 1 or 2 detected by the vehicle when:
•
The vehicle is turned ON.
•
Seating positions have been previously
saved to the same 1or 2button. See
“Saving Seating Positions” previously in
this section.