Removing the Flat Tire and
Installing the Spare Tire
Use the following pictures and instructions to
remove the flat tire and raise the vehicle.
1. Remove the center cap, if your vehicle has
one, by placing the chisel end of the wheel
wrench in the slot on the wheel and gently pry
the cap out.
If the wheel has bolt-on wheel covers, loosen
the plastic nut caps by turning the wheel
wrench counterclockwise.
If needed, finish loosening them by hand. The
nut caps will not come off. Using the flat
end of the wheel wrench, pry along the edge
of the cover until it comes off.
If your vehicle has only wheel nut caps,
loosen the plastic nut caps with the wheel
wrench in a counterclockwise direction.
If needed, finish loosening them by hand.
2. Use the wheel wrench to loosen all the wheel
nuts. Turn the wheel wrench counterclockwise
to loosen the wheel nuts. Do not remove
the wheel nuts yet.
539
To Next Page
Loading...
