Storage 4-3
Additional Storage
Features
Cargo Cover
{
Warning
An unsecured cargo cover could
strike people in a sudden stop or
turn, or in a crash. Store the
cargo cover securely or remove it
from the vehicle.
To use the cargo cover, if equipped:
1. Pull the cover handle toward the
rear of the vehicle.
2. Latch the cover posts into the
retaining sockets on the cargo
area trim panels.
To return the cover to the retracted
position:
1. Pull up on the cover handle to
release the cover posts from the
retaining sockets.
2. Let the cover move forward to
the full retracted position.
To remove the cover:
1. Let the cover go all the way into
the holder.
2. Grasping the driver side cover
end cap, push the cover end cap
toward the passenger side of the
vehicle.
3. Swing the cover rearward and
take it out of the vehicle.
To put the cover in the vehicle:
1. Make sure the cover slot in the
holder faces rearward with the
round surface facing down.
2. Hold the cover at an angle and
place the cover end cap into the
slot in the passenger side trim
panel.
3. Move the other end of the cover
forward and hold it next to the
driver side trim panel slot.
4. Press the end caps in, to allow
the cover to fit into the trim slot.
5. Pull lightly on the cover holder to
make sure it is secure.
On long wheelbase models there
are two cover positions. The slots
furthest forward allow the cover to
be used if the third seat is removed
or folded down. The cover can be
installed and removed from
either side.
To Next Page
Loading...
