EasyManua.ls Logo

GMC Yukon 2025 - Page 126

GMC Yukon 2025
441 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
Instruments and Controls 125
km (mpg) or km/L recorded since the last
t
i
me this menu item was reset. This number
reflects only the approximate average fuel
economy that the vehicle has right now, and
will change as driving conditions change. The
Average Fuel Economy can be reset along with
the trip odometer by touching and holding
the touchscreen display when trip odometer is
displayed on the vehicle status screen.
Current Trip: Displays distance driven, fuel
economy, and time elapsed since vehicle
startup. It resets when you turn your
vehicle off.
Time/Date: Displays current date, time, and
temperature information.
Battery Voltage: Displays the current
battery voltage.
Oil Life: Displays an estimate of the remaining
oil life. If REMAINING OIL LIFE 99% is displayed,
that means 99% of the current oil life remains.
When the remaining oil life is low, the CHANGE
ENGINE OIL SOON message will appear on the
display. The oil should be changed as soon as
possible. See Engine Oil 3 320. In addition to the
engine oil life system monitoring the oil life,
additional maintenance is recommended. See
Maintenance Schedule 3398.
The Oil Life display must be reset after each oil
ch
ange. It will not reset itself. Do not reset the
Oil Life display at any time other than when
the oil has just been changed. It cannot be reset
accurately until the next oil change. To reset,
see Engine Oil Life System 3322.
Fuel Economy: Displays information about
current and average fuel economy.
Oil Pressure: Displays the engine oil
pressure in kPa (kilopascals) or psi (pounds per
square inch).
Engine Hours: Displays the total number of
hours the engine has run. This display also
shows the engine idle hours.
Coolant Temperature: Displays the
temperature of the coolant in either degrees
Celsius (°C) or degrees Fahrenheit (°F).
Transmission Fluid Temperature: Displays the
temperature of the automatic transmission
fluid in either degrees Celsius (°C) or degrees
Fahrenheit (°F).
Tire Pressure: Displays the approximate
pressures of all four tires. Tire pressure is
displayed in either kilopascal (kPa) or in pounds
per square inch (psi). If the pressure is low,
the value for that tire is shown in amber. See
Ti
re Pressure Monitor System 3357 and Tire
Pressure Monitor Operation 3358.
Trailer Brake: On vehicles with the Integrated
Trailer Brake Control (ITBC) system, the trailer
brake display appears in the DIC.
TRAILER GAIN shows the trailer gain setting.
This setting can be adjusted from 0.0 to 10.0
with either a trailer connected or disconnected.
TRAILER OUTPUT shows the power output to
the trailer any time a trailer with electric brakes
is connected. Output is displayed as abar
graph. Dotted lines may appear in the OUTPUT
display if atrailer is not connected.
Trailer Tire Pressure: If equipped, shows the
approximate pressures of all trailer tires. Tire
pressure is displayed in either kilopascal (kPa)
or in pounds per square inch (psi). If the
pressure is low, the value for that tire is shown
in amber. See Trailering App 3301.
Trailer Tire Temperature is located below the
tire pressure. Trailer Tire Temperature shows
each trailer tire temperature in either degrees
Celsius (°C) or degrees FahrenheitF).
Brake Pad Life: Displays an estimate of the
remaining life of the front and back brake pads.
Messages are displayed based on brake pad

Table of Contents

Related product manuals