GMC Yukon 2025 - Page 135

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
134 Instruments and Controls
If the signal is not detected after 30
s
e
conds, press S and return to Step 1 to try
again.
Some garage door openers require
amodification of Step 3. See “Radio
Signals for Some Gate Operators” later in
this section.
4. Once the signal is found, test the Universal
Remote System by pressing the Test
button. You may need to press the Test
button several times, as some garage
door openers require multiple valid signals
when programming. If your garage door
moves, then programming was successful.
Press the It Worked button to validate
programming was successful and end the
process. Continue to Steps 5–8 only if
programming was not successful.
5. If your garage door does not move during
testing, press the It Didn’t Work button.
6. Locate the Learn or Smart button on
the garage door opener receiver in the
garage. The name and color may vary by
manufacturer, but is usually located near
the antenna wire. If you have any difficulty
finding the button, refer to the garage door
opener manufacturer’s instructions.
7. Press and release the Learn or Smart button
o
n the garage door opener receiver. Step
8must be completed within 30 seconds
of pressing this button. If it takes longer
than 30 seconds, you will need to press this
button again.
8. Return to the vehicle and press the Test
button on the infotainment screen. You
may need to press the Test button several
times. If your garage door moves, then
programming was successful. Press the It
Worked button to validate programming
was successful and end the process.
9. If programming is not successful, press It
Didn’t Work button and repeat Steps 6–8.
After your Universal Remote has been
successfully programmed, you can change the
name of the remote on the screen as desired
by pressing y.
For questions or programming help, visit
www.homelink.com/gm for self-help videos
or call 1–800–355–3515. For calls placed outside
the U.S., Canada, or Puerto Rico, international
rates will apply and may differ based on
landline or mobile phone.
Erasing Universal Remotes
To
erase aprogrammed Universal Remote,
press y next to the remote from the list on
the infotainment screen, and then select
“Delete.”
To erase ALL programmed Universal Remotes,
press y next to any remote from the list on
the infotainment screen, and then select
“Delete All.”
Radio Signals for Some Gate Operators
Some gate operators and radio-frequency laws
require transmitter signals to time out or
quit after several seconds of transmission.
This may not be long enough for the
Universal Remote system to pick up the signal
during programming.
If programming did not work, replace Step
3under “Programming the Universal Remote
System,” with the following:
Press and release the hand-held transmitter
button every two seconds until the
signal has been found by the Universal
Remote System. Proceed to Step 4under
“Programming the Universal Remote System”
to complete programming.