GMC Yukon 2025 - Super Cruise

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
234 Driving and Operating
•
P
ress *.
•
Press 5.
Erasing Speed Memory
The ACC set speed is erased from memory if 5
is pressed or when the vehicle is turned off.
Weather Conditions Affecting ACC
System operation may be limited under snow,
heavy rain, or road spray conditions.
Accessory Installations and
Vehicle Modifications
Do not install or place any object around
the front camera windshield area that would
obstruct the front camera view.
Do not install objects on top of the vehicle that
overhang and obstruct the front camera, such
as acanoe, kayak, or other items that can be
transported on aroof rack system. See Roof
Rack System 398.
Do not modify the hood, headlamps, or fog
lamps, as this may limit the camera’s ability to
detect an object.
Do not attach anything to the front or rear
fa
scia as this may interfere with the radar
sensor operation.
{ Warning
S
tickers or accessories attached on or
ar
ound the front or rear fascia of your
vehicle can impair the radar sensors
resulting in vehicle damage or personal
injury. Your vehicle could brake suddenly.
Do not attach anything on or around the
front or rear fascia, including the license
plate, the bumper, or the grille. Use only GM
genuine accessories.
Cleaning the Sensing System
Th
e camera sensor on the windshield behind
the rearview mirror, and the sensors on the
front of the vehicle can become blocked by
snow, ice, dirt, mud, or debris. This area needs
to be cleaned for ACC to operate properly.
If ACC will not operate, regular cruise control
may be available. See “Switching Between ACC
and Regular Cruise Control” previously in this
section. Always consider driving conditions
before using either cruise control system.
For cleaning instructions, see “Washing the
Ve
hicle” under Exterior Care 3388.
Super Cruise
If equipped, Super Cruise can steer to maintain
lane position under certain conditions on Super
Cruise-enabled roads that are separated from
opposing traffic.
Super Cruise can also steer to perform alane
change under certain conditions on Super
Cruise-enabled roads.
A lane change can be initiated by the driver
using the turn signal lever.
If equipped with Automatic Lane Change, the
Super Cruise system may initiate a lane change
maneuver in the following scenarios:
•
To pass slower traffic
•
When the current lane is ending ahead
•
To return to the initial lane
•
To provide space for vehicles merging from
an ending lane
See “Super Cruise Lane Change” later in this
section and Turn and Lane-Change Signals
3139.