GMC Yukon 2025 - Page 371

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
370 Vehicle Care
2. Turn the jack knob counterclockwise to
r
e
lease the jack and wheel blocks from the
bracket. If equipped, remove the wheel
blocks from the jack and place the wheel
blocks on both sides of the tire at the
opposite corner of the tire being changed.
See If aTire Goes Flat 3368 for more
information on the placement of the
wheel blocks. Place the jack and wheel
blocks near the tire being changed.
Short Wheel Base Shown, Extended Wheel
Ba
se Similar
3. Lift the load floor. Remove the jacking
tools and place them near the tire
being changed.
Use the following tools:
1. Jack
2. Wheel Blocks
3. Jack Handle
4. Jack Handle Extensions
5. Wheel Wrench
To access the spare tire, refer to the following
gr
aphics and instructions:
1. Hoist Assembly
2. Hoist Shaft
3. Hoist Shaft Access Cover/Hole
4. Jack Handle Extension
5. Wheel Wrench
6. Spare Tire Lock
7. Hoist End of Extension Tool
8. Hoist Shaft Access Hole
9. Spare Tire (Valve Stem Pointed Up)
10. Tire/Wheel Retainer