GMC Yukon 2025 - Memory Seats

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
Seats and Restraints 41
To activate and adjust the massage feature
f
r
om the front center display screen,
if equipped:
•
Touch E >Massage and then select the
desired adjustment on the seat image.
•
To adjust executive rear seats, if equipped,
select Rear Right or Rear Left.
The massage feature will turn off after
approximately 20 minutes. Press the
massage On/Off control (6) to restart the
massage feature.
Memory Seats
Overview
If
equipped, the memory seat feature allows
drivers to save their unique driving positions
and ashared exit position. See “Saving
Seating Positions” later in this section. The
saved positions can be recalled manually by
all drivers. See “Manually Recalling Seating
Positions” later in this section. Drivers with
remote key 1and 2can also recall them
automatically. See “Auto Seat Entry Memory
Recall” or “Auto Seat Exit Memory Recall” later
in this section. To enable automatic recalls,
turn on Seat Entry Memory and/or Seat Exit
Memory. See “Enabling Automatic Recalls”
later in this section. The memory recalls may
be canceled at any time during the recall.
See “Cancel Memory Seating Recalls” later in
this section.
Identifying Driver Number
The vehicle identifies the current driver by
their remote key number 1–8. The current
remote key number may be identified by Driver
Information Center (DIC) welcome message,
“You are driver xfor memory recalls.” This
message is displayed the first few times the
vehicle is turned on when adifferent remote
key is used. For Seat Entry Memory to work
properly, save positions to the 1or 2memory
button matching the driver number of this
we
lcome message. To aid in identifying remote
key IDs, it is recommended to only carry
one remote key when entering the vehicle.
Perform the following if the welcome message
is not displayed:
1. Move all remote keys away from
the vehicle.
2. Turn the vehicle on with another remote
key. A DIC welcome message should display
indicating the driver number of the other
remote key. Turn the vehicle off and remove
the other remote key from the vehicle.
3. Turn the vehicle on with the initial remote
key. The DIC welcome message should
display the driver number of the initial
remote key.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to 1and 2:
1. Turn the vehicle on or to accessory mode.
ADIC welcome message may indicate the
driver number of the current remote key.
See “Identifying Driver Number” previously
in this section.