GMC Yukon 2025 - Page 43

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
42 Seats and Restraints
2. Adjust a
ll available memory features to the
d
esired driving position.
3. Press and release SET; achime will sound.
4. Immediately upon releasing SET, press and
hold memory button 1or 2matching the
current driver’s remote key number until
two chimes sound. If too much time passes
between releasing SET and pressing 1or 2,
the two chimes will not sound indicating
memory position were not saved. Repeat
Steps 3and 4to try again.
5. Repeat Steps 1–4 for the other remote key
1 or 2 using the other 1 or 2 memory button.
It is recommended to save the preferred driving
positions to both 1and 2if you are the
only driver.
To save the common exit seating position to
B that is used by all drivers for Manually
Recalling Seating Positions and Auto Seat Exit
Memory Recall features, repeat Steps 1–4 using
B, the exit button.
The seat positions can also be adjusted and
saved from the center console display. Touch
E on the display, select the Position tab,
then select and hold the desired position type.
Manually Recalling Seating Positions
Pr
ess and hold 1, 2, or B button until the
recall is complete, to recall the positions
previously saved to that button.
Manual Memory recall movement for 1, 2 or B
buttons may be initiated and will complete to
the saved memory position if the vehicle is in
or out of P (Park).
Enabling Automatic Recalls
•
Seat Entry Memory moves the driver seat
to the selected 1or 2position when the
vehicle is started. Select Settings >Vehicle
>Seating Position >Seat Entry Memory
>ON or OFF. See “Auto Seat Entry Memory
Recall” later in this section.
•
Seat Exit Memory moves the driver seat to
the preferred exit position of the B
button when the vehicle is turned off and
the door is opened. Select Settings > Vehicle
> Seating Position > Seat Exit Memory > ON
or OFF. See “Auto Seat Exit Memory Recall”
later in this section.
Auto Seat Entry Memory Recall
Se
at Entry Memory will automatically begin
movement to the seating positions of the 1or
2button corresponding to the driver’s remote
key number 1 or 2 detected by the vehicle when:
•
The vehicle is turned ON.
•
Seating positions have been previously
saved to the same 1or 2button. See
“Saving Seating Positions” previously in
this section.
•
Seat Entry Memory is enabled. See
“Enabling Automatic Recalls” previously in
this section.
•
The vehicle is in P (Park).
Seat Entry Memory Recall will continue if
the vehicle is shifted out of P (Park) prior to
reaching the saved memory position.
If the saved memory seat position does
not automatically recall, verify the recall is
enabled. See “Enabling Automatic Recalls”
previously in this section.
If the memory seat recalls to the wrong
position, the driver’s remote key number 1or
2may not match the memory button number
positions they were saved to. Try the other