GMC Yukon 2025 - Page 88

GMC Yukon/Yukon XL/Denali Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-17942154) - 2025
Seats and Restraints 87
Caution
Do not let the LATCH attachments rub
against the vehicle’s seat belts. This may
damage these parts. If necessary, move
buckled seat belts to avoid rubbing the
LATCH attachments.
Do not fold the rear seatback when the seat
is occupied. Do not fold the empty rear seat
with a seat belt buckled. This could damage
the seat belt or the seat. Unbuckle and
return the seat belt to its stowed position,
before folding the seat.
The vehicle is equipped with afront center
ai
rbag in the inboard side of the driver seat.
Even with a front center airbag, a child restraint
can be installed in any second row seating
position. If achild restraint is installed in
asecond row center seat, move the second
row seat to the rearward position, whenever
possible, to minimize contact with the front
center airbag.
If you need to secure more than one child
restraint in the rear seat, see Where to Put the
Restraint 379.
1. Attach and tighten the lower attachments
to
the lower anchors. If the child restraint
does not have lower attachments or
the desired seating position does not
have lower anchors, secure the child
restraint with the seat belt and top
tether when recommended by the child
restraint manufacturer. Refer to your child
restraint manufacturer instructions and the
instructions in this manual.
1.1 Find the lower anchors for the
desired seating position.
1.2 Put the child restraint on the seat.
1.3 Attach and tighten the lower
attachments on the child restraint
to the lower anchors.
2. If the child restraint manufacturer
recommends that the top tether be
attached, adjust the top tether to its full
length and attach it to the anchor. Refer
to the child restraint instructions and the
following steps:
2.1 Find the top tether anchor.
2.2 Route, attach, and tighten the
top tether according to your
child restraint instructions and the
following instructions:
2.3 If the position you are using has
afixed headrest or head restraint
and you are using asingle tether,
route the tether around the inboard
or outboard side of the headrest or
head restraint.