Shifting Out
of
NEUTRAL
To shift out of NEUTRAL:
1.
Set the parking brake and apply the regular brake
2.
Shift the transmission to NEUTRAL
(N)
and turn the
3.
Press the button for the desired transfer case shift
4. After the transfer case has shifted out of NEUTRAL
pedal.
ignition to RUN with the engine off.
position (2HI, 4H1, AUTO 4WD OR
4
LO).
the red light will go out.
5.
You may start the engine and shift the transmission
to the desired position.
Excessively shifting the transfer case into or out of the
different modes may cause the transfer case to
enter the shift protection mode. This will protect the
transfer case from possible damage and will only allow
the transfer case to respond
to
one shift per
10
seconds. The transfer case may stay
in
this mode for
up
to
three minutes.
All-Wheel Drive with
§tabilitrak@
With this feature, engine power is sent to all four wheels
all the time.
This is like four-wheel drive, but there is no separate
lever or switch to engage or disengage the front axle. It
is fully automatic, and adjust itself as needed for
road conditions.
Io.ol0~
ON
The transfer case buttons
are located to the left of
the instrument panel
cluster.
Use these switches to shift into and out of four-wheel
drive.
2-32
To Next Page
Loading...
