Replacing
the
Bench Seat
If the seatback isn’t locked,
it
could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward on the seatback to be sure
it
is
locked.
-1
A
seat that isn’t locked into
pLe
properly
,,n
move around in a collision or sudden stop.
People in the vehicle could be injured. Be sure
to lock the seat into place properly when
installing
it.
A
safety belt that
i
mp
.
‘ly routed, not
properly attached, or twisted won’t provide
the
protection needed in a crash. The person
wearing the belt could be seriously injured.
After raising the rear seatback, always check
to be sure that the safety belts are properly
routed and attached, and are not twisted.
To
reinstall the full bench seat, do the following:
1.
While holding the rear of the seat up, slide the front
wheels into the slots on the floor. The front latches
should lock into place. If the latches do not lock,
try tilting the rear of the seats upwards.
2.
Once the latches are engaged, let the seat drop
into place. Release the lever labeled
1
to return
the seat to its upright position.
3.
Push and pull on the seat to make sure it is locked
into place. The seatback cannot be raised to the
upright position unless the seat
is
secured to
the floor.
1-18
To Next Page
Loading...
