EasyManua.ls Logo

GMC YUKON XL 2003 - Windshield Washer Fluid

GMC YUKON XL 2003
516 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Replace the cap and completely tighten it. Then remove
the cap again and look at the fluid level on the
dipstick.
The level should be at the
FULL
COLD mark.
If
necessary, add only enough fluid
to
bring the level up to
the mark.
All
Other
Engines
When to Check
Power
Steering Fluid
It is not necessary to regularly check power steering fluid
unless you suspect there is a leak in the system or
you hear an unusual noise.
A
fluid loss in this system
could indicate a problem. Have the system inspected
and repaired. See
Engine Comparfment Overview
on
page
5-14
for reservoir location.
How
to
Check Power Steering Fluid
What to Use
To determine what kind of fluid to use, see
Part
D:
Recommended Fluids and Lubricants
on
page
6-16.
Always use the proper fluid. Failure to use the proper
fluid can cause leaks and damage hoses and seals.
Windshield Washer Fluid
What to
Use
When you need windshield washer fluid, be sure to read
the manufacturer’s instructions before use.
If
you will
be operating your vehicle in an area where the
temperature may fall below freezing, use a fluid that has
sufficient protection against freezing. See
Engine
Compartment
Overview
on page
5- 14
for reservoir
location.
Turn the key
off, let the engine compartment cool down,
wipe the cap and the top of the reservoir clean, then
unscrew the cap and wipe the dipstick with a clean rag.
5-39

Table of Contents

Related product manuals