15
F
Optional equipment
DRIVER MODE CONTROL
F
/FOUR-WHEEL DRIVE
F
DRIVER MODE CONTROL
The Driver Mode Control settings automatically
adjust various vehicle control systems based on
driving preferences, weather and road condi-
tions. The modes are displayed on the Driver
Information Center.
Rotate the Driver Mode Control knob (A)
on the left side of the instrument panel to
select a mode.
Normal – Use for normal driving.
Sport – Use for enhanced responsiveness on paved roads.
Snow/Ice (2WD only) – Use for enhanced traction during slippery conditions.
O-Road (4WD only) – Use for enhanced control on unpaved roads or trails at
moderate speeds.
Tow/Haul – Use to reduce shift cycling when towing or hauling heavy loads in
stop-and-go trac, rolling hills, or busy parking lots.
Terrain (4WD only
F
) – Press the button
for enhanced control in low-speed o-road
conditions. The system automatically provides
light vehicle braking to simulate engine vehicle
braking. Only available with the single-speed
transfer case when in
.
FOUR-WHEEL DRIVE
Use the four-wheel drive buttons (B) on the left
side of the instrument panel to shift into and
out of four-wheel drive. The Driver Information
Center displays the current status of the
transfer case.
AUTO Automatic 4WD High – Use when traction conditions vary.
2WD High – Use for most streets and highways.
4WD High – Use when extra traction is needed or in most o-road driving.
Shift between
,
, and AUTO at normal driving speeds.
4WD Low (2-Speed Transfer Case
F
) – Use when driving o-road in deep sand,
mud or snow, or on steep hills. Shift into or out of this mode when the vehicle is
stopped or moving less than 3 mph with the transmission in Neutral. Shift the trans-
mission into gear when the indicator light stops ashing.
N Neutral (2-Speed Transfer Case
F
) – Use to dolly or dinghy tow the vehicle. Refer to
your Owner’s Manual for the shift procedure.
See Driving and Operating in your Owner’s Manual.
4WD model shown
A
B
To Next Page
Loading...
