Charge the battery
1. Before charging, check the battery slot to ensure the battery has been properly installed.
2. Plug one end of the telephone charger.
3. Connect the other end of the charger to the power outlet.
4. Begin charging. It can be charged if power or power on off. ▪ In power in the state, when the battery icon on
the screen starts rolling it means it is charged. When the icon is full and rolling stop means full charge. ▪ In
state power, the battery icon at the start of the scrolling screen means it is accused. When the icon is full
and stop rolling means loading is complete.
5. Disconnect the charger from the power outlet.
6. Disconnect the charger and the phone.
Touch Screen using
Press: finger to press the desired option to confirm the selection or start an application.
¬
Long press: Long press of the screen on the current operating interface, icon or input area, you can open the
options menu in the current interface.
¬
Slide: Slide your finger on the screen horizontally or vertically. For example, slide the screen into standby
mode or main menu horizontally to change the page menu.
Drag: long-use finger Press the desired item, drag it to any point on the screen. For example, you can drag the
icon from the main menu to the standby screen.
Make a call
1. In standby mode or in the main menu, press the dialed icon to enter the dialing panel, dial numbers on the
screen to enter the phone number.
2. Press dial icon at the bottom, select the SIM card to dial the number.
3. End press icon to cancel the call.
You have to unlock the phone if the keypad and screen are locked.
You can make calls via messages, call log and contacts. During a call, press the volume
keys to adjust the volume. Your phone supports smart dialing. When entering
numbers, the phone will search for the corresponding contact in the phone book or call
trunk
To Next Page
Loading...