Go Power GP-SWR-A User Manual

5.0 Mounting the Remote
Step 1- Cut out the template (on page 8) attached and position it on the wall
where the remote is to be mounted.
Step 2- Mark the location of the two holes, and the square area to be cut out.
Note: Remote switch assembly requires 0.7” (18mm) minimum clear panel depth.
Step 3- Drill two holes, 7/64” (2.8mm) diameter and remove the cutout area.
Step 4- Feed the connector and wire though the cutout hole in the panel and
route the wire to the inverter receptacle (RS 232 Port).
Step 5-Position the remote switch assembly upright and secure to the panel
using the two screws provided. Plug the phone jack into the inverter. Press the
button to turn the inverter on and off.

Go Power GP-SWR-A Specifications

General

Brand	Go Power
Model	GP-SWR-A
Category	Remote Control
Language	English