MAIN MENU
COPY AUDIO INSERT
1 OPEN MAIN MENU
Press MENU.
2 SELECT “COPY SETTINGS”
Press 1.
3 SET COPY AUDIO INSERT
Press 4 to choose from the following:
L1 (Line 1)
While copying, a new linear audio track will
be recorded from an external audio source
connected to the front audio jacks.
L2 (Line 2)
While copying, a new linear audio track will
be recorded from an external audio source
connected to the rear audio jacks.
Off
Copy Audio Insert is disabled. The existing
audio will be copied.
4 CONNECT AUDIO SOURCE
Connect your external audio source to the
front (Line 1) or rear (Line 2) inputs using
standard RCA audio cables; see notes
below.
5 CUE TAPES
Cue up all devices:
• Source tape in Deck 1.
• Target tape in Deck 2.
• The external audio source (tape player,
CD player, etc.) connected to Line 1 or
Line 2.
6 COPY NEW AUDIO TRACK
Press COPY TAPE on the VCR and PLAY on
your external audio source at the same
time.
• The new audio signal will be copied on
the linear audio track. To hear the new
soundtrack, you must turn off Hi-Fi
audio for the desired playback deck,
see page 13.
NOTES
• If you wish to use a microphone to insert the new audio track, it must be connected to a preamp.
• Do not connect speaker outputs to the VCR.
• If there is no audio signal, the audio track will be blank.
• Copy Audio Insert automatically reverts to “Off” when the VCR is turned off.
Follow these steps to insert a new audio track, such as recorded
music or narration, onto your target tape. The new audio can be
recorded from the front or rear line inputs.
To Next Page
Loading...
Need help?
General
