X
m
w
_L
ACTIVE DECK
ALWAYS
AMERICHROME COPY
ATR
AUDIO COPY INSERT
AUTO
CATV
CH MEMORY
CLEAR
CHANNEL
COUNTER
COPYTAPE
CTR
The deck you have control of To see which deck that
is, look at the LEDs on the front panel of the VCR.
Use the Deck Select key to control which deck
is active. Green : Deck One and Red = Deck Two.
A Timer Recording Event which starts every day of the
week (Sunday - Saturday).
Special circuitry which gives particularly high quality
tape duplication, This is also called HQ Copy.
Auto tracking. Automatically adjusts the tracking for
better picture q_lality. Pressing the PLAY key for 1.5
seconds initiates this feature.
The ability to record new audio flom the audio input
.jacks on the flont panel when copying a tape.
A preset automatic f>ature.
Cable television channel assignments.
During At, to Programming, in the Ttmer Setup
menu, the VCR selects the channels it can tune in, to
add to the channel list used.
A button on the remote control which allows you
to clear programming entries in the Timer Recording
menu. It also resets the counter to zero for the
active deck,
Two buttons on the remote control and on the front
panel which allow you to change to the next higher or
next lower channel. If you use these buttons, the VCR
will only stop at the channels you have programmed
into Channel Memory in the Tuner Setup menu.
A display that describes the relative position of the
tape in hours, minutes and seconds.
A key that initiates the duplicating of a tape in Deck
One to a tape in Deck Two.
The counter key on the remote control.
APPENDIX B-GLOSSARY 59
To Next Page
Loading...
