Need help?Do you have a question about the Gocontrol GC-TBZ48 and is the answer not in the manual?
General| Brand | GoControl |
|---|---|
| Model | GC-TBZ48 |
| Type | Thermostat |
| Compatibility | Z-Wave |
| Display | LCD |
| Humidity Display | Yes |
| Programmable | Yes |
| Hold Function | Yes |
| Fan Control | Yes |
| System Mode | Heat, Cool, Auto, Off |
| Backup Battery Life | Up to 2 years |
| Z-Wave Version | Z-Wave Plus |
| Wireless Protocol | Z-Wave |
| Power Source | Battery |
| Weight | 0.5 lbs |
| Item Weight | 0.5 lbs |
| Temperature Range | 45°F to 90°F |
Steps for removing old thermostat, installing GC-TBZ48, setup, and Z-Wave network integration.
Details on powering the thermostat via 24VAC or batteries, including C-wire requirements and Z-Wave repeater function.
Connecting wires for single transformer standard HVAC systems, including RC/RH jumper use.
Steps for attaching the main thermostat body to the mounted back panel.
Guide on how to open the battery compartment and install AA batteries.
Details on default HVAC settings and when setup adjustments are needed.
Explanation of thermostat delays for compressor protection and cycle assurance.
Instructions on how to access the thermostat's setup and menu modes.
How to use buttons to scroll, select, and exit menu items on the thermostat.
Configuring the thermostat for Standard Gas/Electric or Heat Pump systems.
Setting fan type for standard systems and changeover valve type for heat pumps.
Procedure for adding the thermostat to a Z-Wave network and inclusion/exclusion.
Steps for setting the thermostat's internal clock and date.
Accessing system information like model, firmware versions, and Z-Wave IDs.
Configuring test mode, aux heat enable, staging delays, and minimum run/off times.
Setting maximum and minimum values for heating and cooling setpoints.
Setting the minimum separation (delta) between heating and cooling setpoints.
Defining setpoint deltas for when heating/cooling stages turn on and off.
Explanation of the main screen layout, backlight, and display indicators.
Understanding the indicators for heating/cooling stages and emergency heat mode.
How to select system modes: Off, Heat, Cool, Auto.
Using Emergency Heat mode for heat pumps during compressor failure.
Instructions for adjusting temperature setpoints using up/down buttons.
Understanding how the thermostat maintains setpoint separation.
How to select between Auto and On fan modes for HVAC operation.
Customizing Fahrenheit/Celsius display and backlight timeout settings.
Adjusting temperature calibration and setting the status line display.
Statements regarding regulatory compliance for the device.
Information on the product's one-year limited warranty for wholesale customers.
To Next Page