Need help?Do you have a question about the Gold Medal ShaveMaster II 1005 and is the answer not in the manual?
General| Brand | Gold Medal |
|---|---|
| Model | ShaveMaster II 1005 |
| Category | Ice Maker |
| Language | English |
Machine must be properly grounded to prevent electrical shock to personnel. Do not immerse in water.
Never put fingers or objects into shaver body while motor is running. Serious injury may occur.
Always wear safety glasses when servicing this equipment.
Any alterations void warranty & may cause dangerous situations. Never make alterations.
Do not allow direct public contact; only trained personnel should operate.
Machine is NOT to be operated by minors (under 18 years of age).
Information represents latest data; changes reserved at discretion of Gold Medal Products.
Pull and turn to "unlock" main shaft. Ensure motor is "OFF".
Rotates when motor is "ON". Keep fingers away from it.
Rotate for main shaft to maintain height.
Open door latch, place ice block, close and relatch door.
Rotate clockwise "finger tight" to put pressure on the ice block.
Rotate to minimum shaving height for fine snow.
Hold cup below discharge area, then "shape" by hand. Wear gloves.
Start shaving process here or by using #1008 Foot Switch.
Ensure machine is installed on sturdy, level, and waterproof surface.
Allow ice to soften 1½ hour prior to shaving for fluffy ice.
Raise main shaft using handwheel after unlocking.
Open front shield by releasing safety latch and pulling forward.
Place ice block on shaving platter, centering it.
Lower main shaft until spikes embed in ice block.
Close front shield and reattach safety latch.
Turn Shaving Pressure Knob clockwise to stop for pressure.
Turn "ON" main power switch; motor won't run if shield is open.
Turn knob below platter to desired fineness of shaved ice.
Adjusts pressure on ice; clockwise increases pressure and coarseness.
Adjusts blade height for ice texture; clockwise for coarse, counterclockwise for fine.
Use Gold Medal's plastic Ice Mold with Lid (Part No. 1085) for freezing blocks.
Fill container with cool tap water to 1½" from the top rim.
Firmly press lid onto container until it snaps shut.
Set freezer to 10-15° F and stack molds to slow freezing.
Let water freeze completely for approximately 24-30 hours for best results.
Remove block and place in Gold Medal clear bags (Part No. 3064).
Wipe exterior with a soft cloth dipped in mild dish detergent and warm water.
Detailed steps for dismantling, washing, and reassembling internal components.
Keep main shaft lubricated with Gold Medal Gear Lube; oil crank through holes.
Instructions for removing, replacing, and adjusting the shaver blade.
Remove thumb screws and platter from support casting.
Tighten and then loosen blade adjustment knob by specified revolutions.
Loosen screws holding blade clamp and shaving base.
Adjust blade for straightness and spacing on a flat surface.
Ensure 1/8" gap between blade and slot before tightening base screws.
Tighten blade clamp screws after ensuring blade is straight.
Ensure all screws are tight before placing platter back on support casting.
Identify desired part by checking photos, illustrations, and parts list.
Include part number, name, quantity, model, and serial number when ordering.
Address all parts orders to Gold Medal Products Company, Parts Department.
Place orders via phone, fax, or email for prompt service.
To Next Page