EasyManua.ls Logo

Golding Audio DMS3000 - Page 14

Default Icon
14 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PAGE 14 updated 19/01/06
————————————————————————————————
EXAMPLE 3
This file will play message 1 every 10 minutes.
/loop=255; Run forever once started
/dlrg=011; Minutes timer, run continuous
/dltm=10; Start 10 minute timer
/play=1; Play message 1
/wtan=0101; Wait for end of mp3 and timer end
/goto=4; Repeat
) End of command file
————————————————————————————————–
EXAMPLE 4
This file will play a message from a group of 6 messages in sequence
each time it is tripped.
/loop=255; Infinite loops
/lims=1; First message of group
/lime=6; Last message of group
/sequ=1; Reset sequencer
/sequ=0; Play a message in sequence group
/wtan=1100; Wait for end of mp3 and trip input
/goto=5; Loop back
) End of command file
————————————————————————————————–
EXAMPLE 5
I want to fade up a dimmer then play a message, fade down the dimmer
and then go back to standby.
This command file will turn on the output transistor to call an external
relay. Wait for 2 seconds. Play a message then turn off the relay and wait
a further 2 seconds before exit.
/dlrg=000; Delay range is run once seconds timer
/outp=001; Turn on the control transistor
/dltm=2; Start 2 second timer
/wtan=0001; Wait for timer to end
/play=1; Play the message
/wtan=0100; Wait for end of mp3
/outp=000; Turn off transistor
/dltm=2; Start 2 second timer
/wtan=0001; Wait for timer to end
) Exit
————————————————————————————————–
EXAMPLE 6
This file will play a random message from 8 messages with a variable
time delay between. It will play 25 messages then stop.
To play forever, set "/loop=255;"
/loop=24; Number of loops
/lims=1; Start message of group
/lime=8; End message of group
/timr=000; Variable seconds timer, runs once,
/rndm=1; Play random message
/wtan=0100; Wait for end of mp3
/timv=0; Start timer and wait for time out. Time set by aux pot on
front of board
/wtan=0010; Wait for end of timer
/goto=5; Repeat
) End of command file
Don't forget to set "/pbal=127;" in the "ctl????.txt" file to allow
the bal-
ance control to be used for the variable timer.
Control and Command File Examples
DMS3000 V2.20
Digital Audio Playback Card
Golding Audio Ltd
Unit 8
Peartree Business Centre
Stanway Colchester
Essex CO3 0JN
Tel: 01206 762462 Fax: 01206 762633
Web Site: www.goldingaudio.co.uk
Golding Audio Ltd reserve the right to change specification of this or any product without prior notice being given. Golding Audio will not be held
responsible for any damage caused to any equipment or data, arising from use of the product mentioned herein.