Why does the cut-off wheel on my Goldschmidt Saw cut too slow?
If the cut-off wheel on your Goldschmidt Saw is cutting too slowly, it could be due to insufficient fluid flow or a low relief valve setting. Adjust the flow to the proper lpm. For optimal performance, adjust the relief valve to 145 - 155 bar (2,103 – 2,248 psi). Also, ensure you are using the correct blade for the material you are cutting.
What to do if the cutting disc is not turning or turning too slowly on my Goldschmidt SR 310 H Saw?
If the cutting disc on your Goldschmidt Saw isn't turning or is turning too slowly, it might be due to a few reasons. First, check the hydraulic fluid level and top it off or replace it if needed. Also, inspect the connections and sealings for any leaks; tighten them or replace the sealings if necessary. Another possibility is air in the system, so bleed the system. Finally, check the entire device for any mechanical damage.
Why is the operating handle stiff on my Goldschmidt SR 310 H Saw?
If the operating handle on your Goldschmidt Saw feels stiff, it could be due to excessive counter pressure. Ensure that you are not exceeding 17 bar and 38 lpm. Also, the device may be soiled and require cleaning.
What to do if there is a hydraulic fluid leak in my Goldschmidt SR 310 H Saw?
If you notice a hydraulic fluid leak in your Goldschmidt Saw, it's likely due to damaged sealing. Remove the device and replace the sealings.
Lists standards applied for the machine's conformity with EC directives.
Basic information about the Rail Saw, its use, and power source.
Describes the intended application and misuse of the Rail Saw.
Details operating conditions, temperature limits, and emission levels.
Introduces general safety principles and the importance of the manual.
Provides crucial safety warnings and precautions for operation.
Highlights hazards around the cutting area and hot components.
Specifies requirements for personnel operating or maintaining the machine.
Outlines required personal protective equipment and emergency procedures.
Explains mandatory safety signs and their meanings for operator awareness.
Illustrates and describes the overall physical components of the Rail Saw.
Details technical specifications like dimensions, weight, and hydraulic parameters.
Explains the operational principle of the Rail Saw and its hydraulic power.
Defines the scope of delivery and system limits of the Rail Saw.
Provides step-by-step instructions for safely changing the cutting disc.
Covers pre-operation checks and requirements for safe machine startup.
Guidelines for operating the machine safely and effectively, including mounting and cutting.
Outlines routine inspection, cleaning, and maintenance intervals.
Details the procedure and frequency for replacing hydraulic fluid.
General guidelines and targets for diagnosing and fixing malfunctions.
A table listing common malfunctions, their possible causes, and remedies.
General| Brand | Goldschmidt |
|---|---|
| Model | SR 310 H |
| Category | Saw |
| Language | English |
To Next Page