Arming and disarming
This is only used if wired alarm indicators are connected to the indoor station.
Arming
If an alarm is triggered after arming, an alarm with a link is generated and the
alarm information is uploaded.
• Make sure that the area has been added to the arming mode.
Otherwise, after arming
No alarm triggered.
• Make sure that the system is in disarmed status.
Otherwise, arming will fail.
Step 1 On the home screen, tap to
display all arming modes.
At home: Activate the system when you are within the range of the
alarm system.
Away: Activate the system when you leave the alarm system area.
Sleep mode: An alarm mode that allows you to activate the system during
sleep time.
Customised: Activate the system according to your individual needs.
Step 2 Enter the arming and disarming password in the "In Arming Mode"
window and then tap OK.
Note:
The default password for arming and disarming is 123456. If you want to
change the password, you can find more information under Password. If a
delay time for the alarm is set in the area, the device will sound continuously at
the end of the initial delay time.
To Next Page
Loading...