golmar NEXA Series User Manual

18
MODULE PROGRAMMING
Programming fields:
Continued overleaf
Continued from previous page
Field “6”: Configuring locking mode.
6
Press “6” to select field “6”.
Steps: Field + locking mode + time between attempts + lock time + panic output + key button.
7 C
or
(Step 1)
(Step )7
Set the access control module's locking mode.
Enter one of the following options:
”0”: Never locks.
“3” to “9”: Locks after “3” to “9” failed attempts to enter the user pin.
Allows the access control module's locking mode to be configured.
1
0
(Step )3
Set the minimum amount of time that must elapse between failed attempts before the
access control module is locked. Only takes effect if option “0” has not been selected in
step 2.
The times to select are “01” to “15” minutes or press the key button.
Note: If the key button is pressed, this field value is set as “03” , the “locking time”minutes
field value is “03” , the “panic output” value field is “0” and theminutes not activated
programming of the field finishes
.
(Step )6
Press the key button to finish programming the field.
Note: It is not necessary to press the key button if it has already been pressed in steps
3, 4 or 5.
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
6
0
0
(Step )2
0 1
or
(Step )4
Set the amount of time that the access control module remains in locking mode after the
last wrong code has been entered. Only takes effect if option “0” has not been selected in
step 2.
The times to select are “03” to “15” minutes or press the key button.
Note: If the key button is pressed, the field value is set as “03” , the “panic output”minutes
value field is “0” and the programming of the field finishesnot activated
.
1
0
*
( )
*
( )
0 30 1
*
( )
*
( )
(Step )5
Set the activation of the panic output (terminal “P” of the terminal block) during locking
mode. Only takes effect if option “0” has not been selected in step 2.
Enter one of the following options or press the key button:
“0” : Output not activated.
“1” : Output activated (for 3 seconds in intervals of 1 minute).
Note: If the key button is pressed, the field value is set as “0” and the programming of the
field finishes.
1
0
*
( )
*
( )
or
AUDIO AND VIDEO DOOR ENTRY SYSTEM - ACCESS CONTROL

golmar NEXA Series Specifications

General

Brand	golmar
Model	NEXA Series
Category	Intercom System
Language	English