golmar NEXA Series User Manual

19
MODULE PROGRAMMING
Programming fields:
Continued overleaf
Continued from previous page
Field “7”: Configure the identification ID of the access control module. (Not configure).
7
Press “7” to select field “7”.
Steps: Field + D code + key button.I
8 C
or
(Step 1)
(Step )4
Set an identification code (ID) for the access control module.
Note: Possible identification codes (ID): “000” to “999”.
Allows an identification code (ID) to be configured for the access control module.
Note: Possible identification codes (ID): “000” to “999”.
IMPORTANT: This programming field for standalone access control.is not applicable
(Step )3
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
7
0
0 0
(Step )2
0 0
0
Press the key button to finish programming the field.
Field “8”: Configure depth of field. (Not configure).
8
Press “8” to select field “8”.
Steps: Field + number of calling code digits + direct call + key button.
9
C
or
(Step 1)
(Step )5
Set the number of digits in the calling code.
Enter one of the following options:
“1” or “2” or “3”
Allows the number of digits in the calling code to be configured.
IMPORTANT: This programming field for standalone access control.is not applicable
(Step )4
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
8
(Step )2
2 3
1
Press the key button to finish programming the field.
1 2
or
3
or
or or
0 1
or
Set the direct call: by entering a call code on the keypad if necessary or do not press the
key button to confirm.
Enter one of the following options:
“0” : Disable.
“1” : Enable.
(Step )3
0 1
or
AUDIO AND VIDEO DOOR ENTRY SYSTEM - ACCESS CONTROL

golmar NEXA Series Specifications

General

Brand	golmar
Model	NEXA Series
Category	Intercom System
Language	English