KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 15-
5006892-01
BA-E
®
Observe the fire alarm and fire fighting measures. The personnel must be made familiar with the location and
handling of fire extinguishers!
3.4 Selection and qualification of person
Only permitted personnel is allowed to work on and with the machine! The legal minimum age is to be observed!
Only assign trained and instructed personnel! Clearly define the responsibilites of the personnel with regard to
operating, setting-up, maintaining and repairing the machine! The GÖLZ
®
GmbH can assist you in training your
personnel.
Make sure that only instructed and competent personnel works on the machine. Define the responsibility of the
machine operator, also in terms of traffic regulations and enable him to refuse instructions of third parties which
breach safety regulations.
Personnel that is to be trained or to be instructed or that is serving a general training is only to be permitted to
operate the machine under the supervision of an experienced person.
To operate the machine you must be rested, in good physical condition and mental health. If you have any
condition that might be aggravated by strenuous work, check with your doctor before operating with the
machine. Do not operate the machine if you are under the influence of any substance (drugs, alcohol) which
might impair vision, dexterity or judgment.
Works on electrical, pneumatic, combustion and hydraulic fittings and equipment are only to be carried out by
qualified personnel or instructed people being directed and supervised by qualified personnel in compliance with
the respective rules!
3.5 Safety instructions governing specific operational phases
Before work
Avoid any operational mode that might be prejudicial to safety!
Before beginning work, familiarize yourself with the surroundings and circumstances of the site, such as
obstacles in the working and travelling area, the soil bearing capacity and any barriers separating the
construction site from public roads.
Take the necessary precautions to ensure that the machine is used only when in a safe and reliable state.
Operate the machine only if all protective and safety-oriented devices, such as removable safety devices,
emergency shut-off equipment, sound-proofing elements and exhausters, are in place and fully functional.
Regard all safety specifications!
Check the machine at least once per working shift for obvious damage and defects. Report any changes (incl.
changes in the machine’s working behaviour) to the competent organization/ person immediately. If necessary,
stop the machine immediately and lock it. Have any defects rectified immediately.
At any time, ensure the operator has sufficient view to his working area, in order to have intervention to the
working process.
Wet drilling is to be accomplished while working. This prevents the appearance of particulate matter and
increases the life-time of the diamond tool.
During start-up and shut-down procedures always watch the indicators in accordance with the operating
instructions!
Before starting or setting the machine in motion, make sure that nobody is at risk. Keep children and
unauthorized persons away from the work area.
Noise protection equipment on the unit must be in protective position during operation. Wear the required
individual ear protection!
Attention: Persons with pacemakers only: The ignition system of your machine produces
an electromagnetic field of a very low intensity. This field may interfere with some
pacemakers. GÖLZ
®
recommends that persons with pacemakers consult their physician
and the pacemaker’s manufacturer to reduce any health risk.
To Next Page
Loading...