KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 20-
5006892-01
BA-E
®
4. Bringing into service
4.1 Export checking
Remove the transport packaging and place the unit vertically on a horizontal, flat and stable surface.
Dispose of the transport packaging according to environmental regulations. Since the unit is delivered
completely assembled, you need only check if it is complete and intact.
For the scope of delivery, see "Technical Data and Accessories". In addition, check the travel path of the drill
carriage for proper movement.
4.2 Petrol drill motor FS560
The meanings of the pictrograms attached to the machine:
4.2.1 M-Tronic
The M-Tronic controls fuel feed and ignition timing electronically in all operating conditions. M-Tronic guarantees
simple and fast starts. The engine is started in the Start ▲ position irrespective of climatic conditions or engine
temperature.
After starting, the Start ▲ position can be maintained until the engine runs smoothly. M-Tronic ensures optimum
engine power at all times, very good acceleration and automatic adjustment to suit changing conditions. For this
reason there is no need to change the carburetor setting - the carburetor has no adjusting screws.
If the usual good running behavior and engine power are not reached after an extreme change in operating
conditions, contact your servicing dealer for assistance. GÖLZ
®
recommends that you have servicing and repair
work carried out exclusively by an authorized GÖLZ
®
servicing dealer.
Fuel tank
Fuel mixture of gasoline and engine oil
Operate manual fuel pump
Intake air for summer operation
Intake air for winter operation
Attention: Do not yet turn the engine on! The following work is to be done with the drill
motor being stopped!
To Next Page
Loading...