KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 27-
5006892-01
BA-E
®
4.3.6 Frame extension
The frame extension is used to attach the machine on pipes less than 380mm (15 in.).
Fasten the frame extension with the added screws at the drill rig. Attach the drill rig as described with strap and
spikes.
4.4 Assembling a drill motor
4.4.1 Assembling a drill motor with gear box
The gear carrier is fitted to the drill carriage by default.
Place the motor via the gear box onto the gear carrier and screw the
components with four M10x45 screws, SW17, as well as eight washers
and four nuts.
With the combustion engine FS560 you can attach the operating handle to the support of the
operating handle and secure with the clip splint.
Provide the water supply to the gear box. The water supply is ensured via a
plug connection between the gear carrier and the gear box.
Frame extension Ø 270 - 180 mm
Frame extension Ø 380 - 270 mm
Attention: The following work is to be done with the drill motor being stopped!
To Next Page
Loading...