KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 28-
5006892-01
BA-E
®
Important: Wet drilling is to be accomplished while working! This prevents the appearance
of particulate matter and increases the life-time of the diamond tool!
4.4.2 Changing a drill motor with gear box
Loosen the connection of the water supply to the gear box. The water supply
is ensured via a plug connection between the gear carrier and the gear box.
Loosen the plug connector on the gear box and pull out the water hose.
Loosen the four M10x45 screws, SW17, between the gear box and the
gear carrier.
Remove the four screws as well as the eight washers and the four nuts.
You can remove the drill motor with the gear box from the gear carrier.
With the combustion engine FS560 make sure that the operating handle
is no longer attached to the support of the operating handle.
Assembling a drill motor with gear box
Fit the new drill motor as described under „Assembling a drill motor with
gear box".
4.5 Water supply
The water supply at the interface ensures that the tool is cooled, the dust of the material is bound and the drill
hole is rinsed out.
4.5.1 With water tank-pressurzied type
New delivery: mount first the pressure-hose into the bottom-side-hole and tighten well.
Operation:
• Always make sure that there is no pressure left in the tank before you open the water-filling hole - so lift
red button on top-lock and release eventual existing pressure.
• Depress pump-handle and turn handle left (anticlockwise).
• Fill approx. 10 litres (2.64 US gallons) but do not fill up completely. Put back hand pump and tighten
clockwise.
• Pump up a pressure of approx. 2 bar (29 PSI).
• During drilling a constant pressure of minimum 0,5 bar (7 PSI) is needed to guarantee a frequent water
flow.
Attention: Tools which are only designed for wet cutting, are never to be used without
water supply! Always ensure sufficient water supply!
Attention: For cutting only use water which is free from coarse impurities! Do not use salt
water!
To Next Page
Loading...