KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 29-
5006892-01
BA-E
®
Connection to core drilling machine
Connect Female Coupler on pressure hose to Male Nipple at the water-tap of the core drilling machine. The
water flow is increased or reduced by the water tap.
Release the female-coupler
The water hose is disconnected by pulling the outer sleeve of the female-coupler backwards and pulling off the
connection of the nipple
Safety regulations
Check periodically the pressure-relief-valve for proper function!
The maximum pressure is 6 bar (87 PSI). If the pressure is not released at max., pressure automatically, the
valve has to be replaced immediately. Any sort of damage on the tank (bottle) cracks or bumps, the bottle must
be changed and taken out of operation.
No repairs on the tank are permitted.
Do not expose the filled water tank to sun for a longer time, increased water temperature results in increased
internal pressure! Store water tank empty and protect against freezing!
4.5.2 Public water mains
Connect a 1/2" water hose to the water tap of the core drilling machine. The flow of water is to be regulated by
the tap.
4.6 Angle-drilling
Upon delivery the unit is in the 90°-position. Do the angle adjustment as follows:
Ground frame in delivery position
90°-position
Ground frame turned 180° around
55°-position
Note: Read and observe the operating instructions to the pressurized water container!
To Next Page
Loading...