KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 31-
5006892-01
BA-E
®
Important: Fit the exhaust gas hose when working in closed rooms or below ground level!
5. Operation
5.1 Before starting
Check that your machine is properly assembled and in good condition:
• All parts must be assembled properly and securely.
• The stop switch must move freely.
• Smooth action of choke knob, throttle trigger lockout and throttle trigger - the throttle trigger must return
automatically to the idle position. The choke knob must spring back from the ▲ position to the run position I
when the throttle trigger lockout and throttle trigger are squeezed.
• Check that the spark plug boot is secure - a loose boot may cause arcing that could ignite combustible
fumes and cause a fire!
• Never attempt to modify the controls or safety devices in any way.
Do not operate your machine if it is damaged or not properly assembled!
Pay attention to the whereabouts of the cooling and rinsing water as well as of cutting slurries. Cutting slurries
must be collected, filtered and disposed of. Attach the unit according to the drilling problem. Move the drill bit
with the hand crank to 5mm to the drilling surface.
5.2 Starting the engine
Start the engine at least 3 meters from the fuelling spot. When work in closed or below
ground level it is absolutely necessary to use the exhaust hose!
1. Throttle trigger lockout
2. Throttle trigger
3. Stop switch - with run and stop positions. Press the momentary contact stop switch
to switch off the ignition.
Warning: Never touch rotating parts like drill spindle and drill bit!
Attention: Make sure, that there are no mains in the material and location of the hole to be
drilled!
Attention: Make the site free of parts that might obstruct the operation! Make sure, the drill
bit is well mounted! Make sure, only authorized personnel is in the working area!
To Next Page
Loading...