KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 37-
5006892-01
BA-E
®
Installing the spark plug
• Screw the spark plug into the cylinder.
• Press the spark plug boot firmly onto the spark plug
• Fit the cap on the shroud from the rear and push the lug (Pos. 2) into the
opening (Pos. 3) in the shroud at the same time.
• Swing the cap forwards onto the shroud, insert and tighten down the screw
firmly.
6.6 Replacing the starter rope and rewind spring
• Take out the screws (Pos. 1).
• Lift away the rewind starter.
Replacing the starter rope and rewind spring
If either the starter rope or rewind spring is broken, continue with “removing the rope rotor”. If either the starter
rope or rewind spring are being replaced as a precautionary measure, continue with the following chapter.
Releasing tension on rewind spring
Use the tensioning wrench (Pos. 6). It is available as a special accessory.
• If necessary, swing the pawls (Pos. 2) inwards.
• Rotate the spring clip (Pos. 3) out of the recesses (Pos. 4) in the carrier (Pos. 5).
• Position the tensioning wrench in the carrier so that the peg (Pos. 6) engages one of
the recesses (Pos. 4).
• Use starter grip to pull out the starter rope as far as stop.
• Hold the tensioning wrench and the starter mechanism steady so that the rope
does not rewind onto the rope rotor.
• Grip the rope inside the housing, pull it out to its full length and make a loop.
• Allow tensioning wrench to rotate slowly and thus release spring tension. The
rope winds itself around the tensioning wrench in this process until the spring is
no longer under tension.
• Remove the tensioning wrench from the carrier.
Attention: If the spark plug comes with a detachable adapter nut (Pos. 1) screw the adapter
onto the thread and tighten it down firmly to reduce the risk of arcing and fire!
To Next Page
Loading...