GÖLZ KB 300 - Fuel Pickup Body in Tank; Spark Arrestor in Muffler and Spacer; Maintenance and Care Engine

KB300 / KB350 with FS560
Translation of the original operating instruction and spare parts list
- 40-
5006892-01
BA-E
®
• Take one turn of the rope off the rotor.
Installing the rewind starter
• Position and line up the rewind starter on the engine
• Insert the screws (Pos. 1) and tighten them down firmly.
6.7 Fuel pickup body in tank
• Check the pickup body in the fuel tank every year and have it replaced if
necessary.
The pickup body should be positioned in the area of the tank shown in the illustration.
6.8 Spark arrestor in muffler and spacer
• The spark arrestor is country-specific.
• If the engine power decreases, check the spark arrestor in the silencer.
6.9 Maintenance and care engine
The following intervals apply to normal operating conditions only. If your daily working time is longer or operating
conditions are difficult (very dusty work area, etc.) shorten the specified intervals accordingly.
before starting
work
after finishing
work or daily
after each
refuelling stop
weekly
monthly
annual
if problem
if damaged
if required
Complete machine
Visual inspection (condition,
leaks)
X X
clean
X
Replace any damaged parts
X
Control handle Check operation
X X
Air filter, paper filter Visual inspection
X X
Attention: When the starter rope is fully extended it must still be possible to rotate the rotor
at least one more turn. If this is not the case, the spring is overtensioned and could break!