MS400
Translation of the original operating instruction and spare parts list
- 23-
5007045-00
BA-E
®
• Make sure that the blade is not touching the cutting table at
any position of the cutting table or cutting head.
• Tighten strongly the adjusting handle and make sure the
cutting head is well fixed and cannot move.
• Put the material on the cutting table. By using the back square
control the position of the material.
• Start the machine.
• Put your left hand on the table pushing handle. Put your right
hand on the cutting head handle.
Your right hand should be ready to push the emergency stop
in case of any unexpected problem.
To Next Page
Loading...