MS400
Translation of the original operating instruction and spare parts list
- 24-
5007045-00
BA-E
®
• Push the cutting table slowly and without undue pressure
towards the rotating blade. The blade cuts the applied
material.
5.3.2 Cutting method: Free depth cutting for multiple steps cutting
In free depth cutting, the cutting head is not locked in a fixed position. This cutting method enables
multiple steps cutting which consists of moving the table back and forth with the material to be cut
under the rotating blade. For hard material, it is recommended to use this cutting method (e.g. by
doing many shallow cuts).
To do free depth cutting, please follow this procedure:
• Switch off the machine and make sure the blade is not rotating.
• Loosen the adjusting handle.
• Adjust the depth stop and tighten the counter nut to fix it well.
To Next Page
Loading...