SYSTEM OPERATION
7
This is a Category lV furnace. This furnace uses a pressurized
venting system and must be installed per National and local
codes requirements and the installation manual that was
shipped with the furnace.
The *MEC96 34.5” furnace is one of the products in our newly
redesigned line of shorter chassis furnaces. It is available
installation.
*MEC960303ANA *CEC960402BNAA
*MEC960403ANA *CEC960603BNAA
*MEC960603ANA *CEC960803BNAA
*MEC960302BNA *CEC961005CNAA
*MEC960402BNA Suitable for counter
*MEC960603BNB installation.
*MEC960803BNA
*MEC960804CNA
*MEC961004CNA
*MEC961005CNA
*MEC961205DNA
Please adhere to the following warnings and cautions when
installing, adjusting, altering, servicing, or operating the
furnace.
T
RT R JR R T T RR TT
JTT
TRT R R T
R
R
T
T
R T T R RT T
Q TR
R
G R T G R
T
RT T R R R
R R T R K T T
TT
R T R BRT T R TR
RRT R
T
RT B RRT G R JR R T
T TR K T R T B T T RT
T
T TR T R TR
Discharge body’s static electricity before touching
components.
Use the following precautions during furnace installation
and servicing to protect the integrated control module from
damage. By putting the furnace, the control, and the person
at the same electrostatic potential, these steps will help
avoid exposing the integrated control module to electrostatic
discharge. This procedure is applicable to both installed and
uninstalled (ungrounded) furnaces.
1. Disconnect all power to the furnace. Do not touch the
integrated control module or any wire connected to the
control prior to discharging your body’s electrostatic
charge to ground.
2. Firmly touch a clean, unpainted, metal surface of the
furnace near the control. Any tools held in a person’s
hand during grounding will be discharged.
3. Service integrated control module or connecting wiring
following the discharge process in Step 2. Use caution
not to recharge your body with static electricity; (i.e., do
objects, etc.). If you come in contact with an ungrounded
object, repeat Step 2 before touching control or wires.
4. Discharge any static electricity from your body to ground
before removing a new control from its container. Follow
Steps 1 through 3 if installing the control on a furnace.
Return any old or new controls to their containers before
touching any ungrounded object.
This product is designed for use as a residential home gas
furnace. It is
trailer, or recreational vehicle applications.
This furnace can be used in the following non-industrial commercial
applications:
In such
applications, the furnace must be installed with the installation
instructions.
appropriate for use with natural or propane gas. (If
using propane gas, a propane conversion kit is required).
optional and the furnace can be vented as a:
• Non-direct vent (single pipe) central forced air furnace in
which combustion air is taken from the installation area
or from air ducted from the outside or,
• Direct vent (dual pipe) central forced air furnace in
which all combustion air supplied directly to the furnace
burners through a special air intake system outlined in
this manual and the installation instructions.
To ensure proper installation, operation and servicing,
thoroughly read the installation and service manuals
application of this product.
B RRT G R JR R T T R
X K T T TR K R RB
X RT R RR TT RR RT
R T T RT
To Next Page
Loading...