SYSTEM OPERATION
16
Connecting Phone Application to Furnace
, ensure the thermostat is in an idol state (no
cool, heat or fan calls). To do this, set the thermostat
fan mode to Auto (not ON) and then remove any active
heat / cool calls. This task needs to be completed within
5 minutes of the process beginning.
, provide any 24VAC call to the control from the
thermostat (cooling, heating or fan will work). This task
must occur within 8 minutes after the Step 1 is complete.
, remove the call that was provided during Step
2. This task must be completed within 1 minute after the
call is provided during Step 2.
To Next Page
Loading...
