English • Owner´s manual
35
Model G6 and G6+
1. Fold the handlebar stem up, fasten it, and put
down the kickstand.
2. Install the handlebar onto the stem.
ATTENTION
Make sure that the cable is correctly inserted into the
bottom of the shaft.
3. Tighten the screws onto both sides of the stem
with the hexagon wrench
ATTENTION
Make sure that the bore holes in the handlebar and
shaft match.
4. After assembly, press the power botton to check if
it´s working properly
G6 and G6+ handlebar assembly video
If you have any further questions about how to correctly install the scooter
handlebars, scan this QR code to access the step-by-step video or visit our
Goodyear Power Youtube channel for more how-to videos.
To Next Page
Loading...