GoPro Omni Guide
Pre-Check: Make sure all GoPro’s have been fully
charged and have formatted SD cards
1) Turn on Omni by locating camera #1
and holding “Mode” until the red light
flashes
a) The rest of the cameras should
turn on automatically, however
you can turn them on manually
if they don’t.
2) The #1 Camera controls the entire
Omni and will display a flashing “AR”
and “Array Ready” when it is ready to
be used
3) Begin recording with the top red
button on camera #1, and then stop
recording with the same button
4) Turn off the Omni with camera #1 by
holding “Mode” until the red light
flashes
To Next Page
Need help?
General
