Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage and debris. Select a at surface
for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it.
• In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket
is available and it is possible to connect a fumes discharge device to the outside (only suction version).
• Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the discharge tube).
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a quali ed technician must verify suitability
of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile,
grout or silicone this appliance to the wall. Surface mounting only.
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for
5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
If you press the button when the ventilation hood in operation, the appliance is OFF
If you press the button the hood is ON and takes the speed 1
If you press the button (the hood is ON) the speed of the motor increases from 1 to more intensive
Speed 1:1
Speed 2:2
Speed 3:3
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat lters) inter-
nally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products.
Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the lters may cause re risks.
Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any re
damage linked to inappropriate maintenance or failure to observe the above safety recommendations.
Traps cooking grease particles. The grease lter must be cleaned once a month using non aggressive detergents, either by hand or in the
dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease lter may discolour slightly,
but this does not affect its ltering capacity. To remove the grease lter, press it and pull it down.
( lter version only)
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal lter occurs after more or less prolonged use, depending on
the type of cooking and the regularity of cleaning of the grease lter. In any case it is necessary to replace the cartridge at least every four
mounths. The charcoal lter may NOT be washed or regenerated.
The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration up to 10 times
as long as the traditional lamps and allow to save 90% electrical energy.
For replacement, contact the technical service.
To Next Page
Loading...
