Need help?Do you have a question about the Gossen MetraWatt M273A and is the answer not in the manual?
General| Resistance Measurement | Yes |
|---|---|
| Max Current | 10 A DC |
| DC Current Ranges | 10 A |
| Battery Type | 1.5V battery for resistance measurement |
| Continuity Test | Yes |
Instructions for handling, charging, and inserting the rechargeable battery pack.
How to select measurement functions and ranges, including auto and manual modes.
Explanation of the instrument's auto-ranging capability for measurements.
How to save and view minimum and maximum measured values over time.
How to record measurements, either one-time or as a series.
Setting up and starting automatic recording of measurement series.
Step-by-step guide for performing insulation resistance measurements.
Steps to prepare for insulation resistance testing, including cable checks.
The procedure for conducting the actual insulation resistance measurement.
How to safely end measurements and discharge the test device.
Guide for measuring inter-turn short circuits using adapters.
Detailed steps for using the COIL TEST ADAPTER for short circuit tests.
The process of conducting the inter-turn short circuit measurement.
Safely ending the inter-turn short circuit measurement and discharging the device.
Guide for using the ADAPTER XTRA for inter-turn short circuit tests.
The process of conducting the inter-turn short circuit measurement using the ADAPTER XTRA.
Safely ending measurements and discharging the test device.
Procedure for measuring the absorption index (DAR) for insulation testing.
Procedure for measuring the polarization index (PI) for insulation assessment.
Procedures for measuring AC and DC voltages, including frequency and filter options.
Measuring AC voltage and frequency, with optional low-pass filter.
Measuring DC and combined AC/DC voltages.
Procedures for measuring electrical resistance.
Procedures for measuring capacitance.
Measuring temperature using Pt100 or Pt1000 resistance thermometers.
Measuring temperature using a type K thermocouple.
Performing continuity tests with audible feedback.
Testing diodes using a constant current source.
Measuring low resistances using the 2-wire method.
Measuring low resistances using the 4-wire (Kelvin) method.
Performing milliohm measurements with 200mA or 20mA test current.
Measuring milliohms with 1A current and automatic thermovoltage correction.
Procedures for measuring AC and DC current.
Measuring DC and AC/DC currents directly.
Measuring AC current and frequency directly.
Measuring DC and AC/DC currents using a current clamp sensor.
Measuring AC current and frequency using a current clamp sensor.
Creating and managing sequences of measurements for repetitive tasks.
Step-by-step guide to creating a new measurement sequence.
How to execute a configured measurement sequence.
Setup and usage of the Bluetooth interface for wireless communication.
Step-by-step guide to establishing a Bluetooth connection.
Overview of software for data transfer and analysis.
Details on using the PC software for data management.
Using the METRALOG app for mobile data acquisition and display.
Using PC software for managing and creating test sequences.
To Next Page
