5.10 Battery charge
When an ATV needs charging, there are two ways to charge the battery. In
the first method, open the cushion and pull out the battery wiring port (No.
1 in Figure 11), take out the battery, and plug the charger into the battery
outlet on the battery to charge; In the second method, directly plug the
charger into the vehicle charging port located at the lower left of the rear of
the car (No. 4 in Figure 11) for charging. It takes about 3-5 hours for the
battery to go from being dead to fully charged.
Figure 11 Figure 12
1.Battery port 2.Battery 3.Battery room 4.Charge port
5.11 Seat cushion
1. Remove the seat cushion: pull back the seat cushion lock (No. 1 in Figure
13) under the seat cushion and pull the seat cushion upward to remove the
seat cushion;
2. Install the seat cushion: Insert the front clamping foot of the seat cushion
at the front of the seat cushion (No. 3 in FIG. 14) under the front hanging
plate of the seat cushion of the frame (No. 2 in FIG. 14), and press the seat
cushion under the seat cushion until it is locked;
（Figure 13） （Figure14）
1. Seat cushion lock 2. Seat cushion front hanging plate 3. Seat cushion
front foot stuck
To Next Page
Loading...