5.12 Electrical service cover
The electric parts are integrated in the car body plastic parts, mainly DC
converter, horn, plug-in electrical parts, controller; It is located above the
headlamp and behind the direction post, and the electrical parts are sealed
by the head cover (No. 1 in FIG. 15) and the electrical cover (No. 2 in FIG.
15). When the ATV electrical parts need to be repaired, the head cover or
the electrical cover can be removed for viewing or maintenance:
Method: Remove the head cover with a Phillips screwdriver, remove the left
and right tapping screws under the lower cover of the instrument at the
back of the head cover, and push the head cover forward to remove the
head cover; Remove the electrical cover by using a Phillips screwdriver to
remove the two self-tapping screws in the rear of the electrical cover and in
front and below the seat cushion, and then push the electrical cover
backward to remove the electrical cover;
（Figure 15）
1.Head cover 2.Electrical cover
5.16 Motor transmission refueling hole, oil drain hole and oil
replacement
Before replacing the oil of the motor transmission, the oil in the
transmission should be cleaned out. The oil drain hole of the transmission is
To Next Page
Loading...